Fitting and care

Fitting a Sungrabba dash mat

Each mat comes with 4 hook Velcro sheets. Pick a warm day if you can – the adhesive grips best on a warm, dry dash.

1. Clean the dashWipe the dash top with a damp cloth to remove dust and protectant, then let it dry fully.
2. Dry fit the matLay the mat on the dash and line up the cut-outs with the vents, speakers and sensors.
3. Place the VelcroLift the front edge and stick the Velcro sheets to the dash where the mat will cover them, near the corners and centre.
4. Press it downLower the mat and press it firmly over each Velcro sheet so the hooks grab.

The mat can be lifted off for cleaning and pressed back down any time.

Caring for your dash mat

• Vacuum it or brush it down while it's on the dash.
• For marks, lift it off and sponge it with mild soapy water, then let it dry in the shade.
• Avoid silicone dash sprays under the mat – they stop the Velcro holding.

Fitting Sandgrabba floor mats

1. Remove the old matsTake out any factory or aftermarket mats so the new ones sit flat on the carpet.
2. Position each matLay each mat in its footwell and push it forward so the raised edges sit up against the sill and firewall.
3. Fit the sill fasteningFit the door-sill fastening so the driver's mat can't slide under the pedals.
4. Check the pedalsPress each pedal all the way down to make sure nothing catches.

Cleaning Sandgrabba floor mats

Lift them out, shake out the sand, hose them off and let them drip dry before you put them back. For greasy marks, a soft brush and dishwashing liquid does the job. There's no need for tyre shine or protectants – they make the mats slippery.

Fitting QMCC moulded flooring

Moulded flooring replaces your whole floor covering, so it's a bigger job. If you haven't done it before, a motor trimmer or mechanic can fit it for you.

1. Remove the seatsUnbolt the seats and seatbelt anchors and store the bolts in order.
2. Remove trimsTake off the sill plates, kick panels and any trims that sit over the floor covering.
3. Lift the old floorRemove the old carpet or vinyl and keep it as a pattern.
4. Lay the new floorLeave the new floor in the sun for an hour so it relaxes, then lay it in and work it into the contours from the centre out.
5. Cut the openingsUse the old floor as a guide to cut holes for seat bolts, belts and the gear lever.
6. RefitRefit the trims, seatbelt anchors and seats, and torque the bolts to the manufacturer's spec.

Caring for moulded flooring

• Carpet: vacuum regularly and spot clean with a carpet cleaner.
• Vinyl: wipe or hose clean, and let it dry before refitting the mats.
• Add Sandgrabba floor mats on top to keep new carpet looking new.